Installing The Harmony H8 Tm Controller; Installing The Harmony H3 Tm Controller - NuVinci Harmony 330 Owner's Manual

6.8 Installing the Harmony H8 Controller
1. Install right brake lever according to the
manufacturer's instruction.
2. Slide the H8 controller (A) onto the
handlebar.
3. Install the right hand grip (B) onto the
handlebar according to the manufacturer's
instructions
4. Position the contoller such that the display
(C) is visible to the rider and the cable will
be unobstructed
•
Tighten the clamp bolt to 2.0-2.5 Nm (18-
22 in-lbs).

Never use lubricants or solvents to
!
install handlebar grips.
 Make sure that the controller and the
!
brake lever function properly and are
unobstructed (re-adjust if necessary).

Never ride without the handlebar
!
grips. The turning grip of the Shifter
could become loose. This can result
in a severe injury.
TECHNICAL OWNER MANUAL
A
B
C
6.9 Installing the Harmony H3 Controller
1. The H3 controller mounts to a rubber base
that wraps around a standard handlebar,
adjacent to the grip.
2. Use the supplied rubber o-ring to secure
the H3 controller, and position such that
the display is visible to the rider and the
cable will be unobstructed.
•
The H3 controller can be mounted to either
right or left sides of the handlebar
HARMONY ASSEMBLY OF COMPONENTS
EN
18