Installing The Rear Wheel For Manual - NuVinci enviolo CT Assembly Instruction Manual

Manual system:
INSTALLING THE REAR WHEEL
W
A
A
A
Improper installation of the no-turn
washer may result in damage to the
dropout and the hub.
enviolo Assembly Instruction
A
A
Over-tightening may damage parts.
Under-tightening can result in the axle
sliding in the dropouts.
Installing the Rear Wheel
for Manual Variants
[W]
2b. For the variants enviolo SP:
For 135mm variants:
• Place the disc rotor onto the hub as specified by the supplier.
Place the torque adapter and secure it with the snap-ring. Orient
the axle plate so the rectangular boss engages in the dropout of
the frame and the cable housing can enter the hub interface in a
straight line
• Secure it with the supplied M4 bolts to 2.5-3Nm. Mount the
threaded adapter and tighten to 10-15Nm Place the rear wheel in
the frame with the axle plate sliding into the dropout. Mount the
lock washers and acorn nuts and tighten to 30-40Nm.
For 142/148mm variants:
• Place the disc brake rotor on the hub. 148 mm variants require
an extra adapter to be placed under the rotor and need to be
tightened with the longer bolts supplied with the kit. 142 mm
variants don't need special adapters or bolts. Tighten the rotor
bolts as specified by the supplier.
• Place the torque adapter onto the axle and secure it with the
supplied snap ring. Orientate the torque adapter plate so it
slides into the boss on the brake adapter or dropout and the
cable housing can enter the hub interface in a straight line. Then
tighten it with the supplied M4 bolts to 2.5-3Nm.
• Place the rear wheel in the frame with the torque adapter sliding
into the slot in the dropout or disc adapter and install the left and
right side adapters securing the axle with the M6 bolts to 10-15
Nm
For rim and roller brake applications, connect the rear brake
according to the manufacturer's instructions.
25