NuVinci enviolo CT Assembly Instruction Manual page 22

Manual system:
INSTALLING THE SHIFT CABLES
Q
R
114mm for Standard controller
S
enviolo Assembly Instruction
102mm for One-turn
•
Cut the excess cable as short as
possible, at a maximum of 2.0mm from
the end of the UD cable stop [Q].
•
Pull the overdrive shift cable firmly
at the manual hubinterface until it stops,
checking to make sure that the shift
indicator [Q] goes into a steep hill
(enviolo TR and SP shifters), or that the
grip rotates fully in the clockwise
direction shown (enviolo CT, CA, CO
shifters, viewed from right side of
bicycle).
•
Make sure the underdrive shift cable and
UD cable stop are free and unobstructed
•
Pass the overdrive shift cable through
the OD Latch [R] and secure the OD
latch at the distance shown [S] while
pulling the cable firmly.
•
Ensure that the cable housing is seated
fully at the shifter.
•
Using a 2mm allen, secure the cable and
torque to 1.5-2.0 Nm (13-18 in-lbs).
•
Cut the excess cable at the OD latch
marking, and tuck the remaining cable
length into the OD latch.
•
The cable hardware should appear as
shown.
22