AUTOMATiQ system:
PAIRING HUB INTERFACE WITH APP
AND CONTROLLER
J
K
A
enviolo Assembly Instruction
PAIRING THE AUTOMATiQ
CONTROLLER
•
After the welcome screen disappears you
will see a connection request
•
Power on your drive system.
•
Push the button on the front side of the
hub interface and hold it for 5 seconds.
•
The button will start blinking blue.
•
The device should now appear on your
screen.
•
Click on your preferred device to start
the pairing process.
•
After pairing is complete you will see the
menu screen.
•
Initiate the pairing mode on the hub
interface again.
•
For the CA controller:
Press and hold the center button for
more than 8 seconds. Once the LED
lights continously in blue for 1 second
the device is paired.
For the CO controller:
Press and hold the center button for 3
seconds until the LED starts flashing
green and red. Once the LED flashes
green only, the device is paired.
For the SP controller:
Press and hold the mode button for 3
seconds. Once the LED lights continuously
in green for 5 seconds the device is paired.
37