Installing The Automatiq Hub Interface - NuVinci enviolo CT Assembly Instruction Manual

AUTOMATiQ system:

INSTALLING THE AUTOMATiQ HUB INTERFACE

E
Find your enviolo serial numbers in these positions:
CT TR CO SP
CVP CVP
enviolo Assembly Instruction
CA
Automatic Interface
CVP
AUTOMATiQ
Hub Interface
Compatibility
& Orientation
•
Ensure you have the correct AUTOMATiQ
Hub Interface for your internal gear hub.
•
enviolo CT/CO/TR have one axle
diameter and enviolo CA/SP, a different
one.
•
You can find the identification of the
AUTOMATiQ Hub Interface variant at the
bottom of the hub interface.
•
Use the uninstalled enviolo hub interface
to determine the desired orientation.
•
Orientation should be forward, parallel
to the chain stay with the automatic
main connector facing forward.
•
Move the AUTOMATiQ Hub Interface
alongt he dropout to ensure clearance at
different axle positions.
•
With the AUTOMATiQ Hub Interface
oriented correctly inside the right
dropout, the installation angle is the
indicated angle of the dropout (20
degrees in this example).
•
Use the markings on the automatic hub
interface to determine your approximate
installation angle.
AUTOMATiQ Interface Controller
29