Setting The Shift Cable Length With The Enviolo; Tool - NuVinci enviolo CT Assembly Instruction Manual

Manual system:
SETTING THE SHIFT CABLE LENGTH WITH THE EN-
VIOLO TOOL
T
Multi-turn
CE-HW-TOOL-SM-CNC
enviolo Assembly Instruction
One-turn 1.5 - 2.0 Nm
•
To simplify shift cable assembly we
have developed a cable installation tool,
which will help you to setup the proper
cable length [T].
•
Pass the shift cables through the
appropriate cable housing and ensure
the housing is seated completely into the
controller.
•
Thread both barrel adjusters completely
clockwise (in) to provide maximum
installation slack.
•
Insert the underdrive cable (marked
black or green) into the according fixture
on the cable cutting tool. Ensure that the
display is in full underdrive by pulling the
cable to the maximum position (display
icon should be flat).
•
Using a 2mm allen, secure the cable and
torque to 1.5-2.0 Nm (13-18 in-lbs).
•
Cut the excess cable as short as
possible, at a maximum of 2.0mm from
the end of the UD cable stop.
•
Now insert the overdrive cable latch
the according fixture and guide the
underdrive cable through.
•
Pull the underdrive cable and secure it
with a 2 mm allen to 1.5-2.0 Nm (13-18 in-
lbs).
•
Cut the cable flush with the cable stop
fixture and tuck the remaining cable
length into the OD latch.
in
23