NuVinci enviolo CT Assembly Instruction Manual page 50

Care and Maintenance
Wear Parts and Repair Work
C
D
B
A
E
enviolo Assembly Instruction
A
A
B
2. Disconnecting
the Rear Wheel
for AUTOMATiQ
Variants
1. Switch eBike power "off" and disconnect the eBike
battery (if possible).
[C]
2. Remove the AUTOMATiQ main connector at
the rear wheel
Grab the connector at the connector (A) and pull
lightly away from the AUTOMATiQ Hub Interface/
the frame.
Do not pull on the cable, only at the
ribbed connector hall as shown.
The connector supplies electrical
power to the AUTOMATiQ Hub Interface.
Protect the connector from water
or other conductive elements when
disconnected, as shock or damage to
the system could result.
3a. For the variants enviolo CT/TR/CO/CA:
[D]
Loosen and/or remove the axle nuts (A),
followed by the no turn washers.
For rim and roller applications follow the
manufacturer´s instructions.
3b. For the variants enviolo SP:
1. 135mm variants: Loosen and remove the axle
nuts and washers.
For rim brake applications follow the
manufacturer´s instructions.
2. 142/148mm variants: Loosen and remove the
axle bolts and left side adapter.
For rim brake applications follow the
manufacturer´s instructions.
[E]
4. Remove the rear wheel
Some eBikes may require rotating the hub axle
and AUTOMATiQ Hub Interface to allow removal of
the bicycle chain. In some cases, it is easiest to
remove the chain from the front chainring to ease
the rear wheel removal.
50