NuVinci enviolo CT Assembly Instruction Manual page 30

AUTOMATiQ system:
INSTALLING THE AUTOMATiQ HUB INTERFACE
F
G
A
B
H
enviolo Assembly Instruction
A
B
I
Installing the
AUTOMATiQ Hub
Interface
•
Remove the anti-shift retainer, if installed.
•
Suspend the AUTOMATiQ Hub Interface over the
right hand axle, and align the axle flats with the
installation angle.
•
Alternatively, a no-turn washer can be installed
over the AUTOMATiQ Hub Interface to align the
installation angle.
•
When the installation angle is aligned seat
the AUTOMATiQ Hub Interface fully onto the shift driver
and the spline nut until it is flush with the spline nut.
•
Thread the r.h. nut serrations facing
outward, onto the axle and tighten to 10-15 Nm (7-11
ft-lbs).
•
Install the rear wheel.
•
Once assembled the hub interface should not touch
the frame.
•
[H] For the variant enviolo SP 135 mm:
Thread the adapter shafts into the hub and tighten to
10-15Nm.
•
[I] For the variants enviolo SP 142/148 mm:
Place the spacer on the hub and thread the LNUT onto the
axle and tighten to 5-6 Nm
30