Installing The Harmony Hub Interface - NuVinci Harmony 330 Owner's Manual

6.7 Installing the Harmony Hub Interface

1. Remove the anti-shift retainer, if installed
(reference section 6.2)
 N330 and N360/N380/N380
!
series CVPs have different shift driver
configurations, and are compatible
only with the appropriate Harmony Hub
Interface. Reference section 6.6.
Shift driver position does not matter

!
during assembly of Harmony
products; the calibration process will
automatically determine shift driver position.
2. Suspend the Harmony Hub Interface over
the right hand axle, and align the axle flats
(A) with the installation angle determined
in section 6.6.
•
Alternatively, a no-turn washer (B) can be
installed over the Harmony Hub Interface
to align the installation angle.
3. When the installation angle is aligned seat
the Harmony Hub Interface fully onto the
shift driver and the spline nut until it is flush
with the spline nut, as shown.
4. Thread the r.h. nut (C), serrations facing
outward, onto the axle and tighten to 10-
15 Nm (7-11 ft-lbs).
5. Install the rear wheel per section 5.2.
TECHNICAL OWNER MANUAL
A
SE
B
C
C
HARMONY ASSEMBLY OF COMPONENTS
EN
17