Rear Wheel - NuVinci Harmony Owner's Manual

BASic MAiNTENANcE AND cArE
Disconnecting the

rear Wheel

„ Switch e-bike power "off" and
disconnect the e-bike battery
(if possible).
1 Remove the Harmony Main
Connector at the rear wheel.
„ Grab the connector at the
EN
ribbed location (1) and pull
lightly away from the
Harmony Hub Interface.
Do not pull on the cable, only
at the ribbed connector half
as shown.
The connector supplies electri-
cal power to the Harmony unit.
Protect the connector from
water or other conductive ele-
ments when disconnected, as
shock or damage to the system
could result.
Loosen and remove the axle
2
nuts (2) and the no-turn washers (3).
„ For rim and roller brake
applications, disconnect the
rear brake according to the
manufacturer's instructions.
3
Remove the rear wheel.
„ Some bicycles may require
rotating the N360 Axle and
Harmony Hub Interface to allow
removal of the bicycle chain.
„ In some cases, it is easiest to
remove the chain from the front
chain ring to ease rear wheel
removal.
4
1 1
2
3
2
3
1
2
3