Installing Shift Cable Housing - NuVinci Nfinity Series Owner's Manual

3.6 Installing Shift Cable Housing

1. Route cable housing as shown from the
shifter to the Nfinity Hub Interface.
2. Measure, cut and install the appropriate
length cable housing (A) for the bicycle.
•
Full-length housing is recommended for
both shift cables.
•
Make sure that the cable housing lengths
are sufficient to allow an extreme turning
angle. Also consider the influence of
adjustable handlebars and stems on the
cable housing lengths.
3. Secure cable housing to the frame.
•
The cable housing must remain moveable
for axle adjustment.
•
Avoid tight bends when installing the shift
cable housing.
•
Leave at least 150mm of housing
unsupported at the Nfinity Hub Interface to
ease installation and removal of the shift
cable hardware.
4. With the housing length correct, install end
caps (B) at both ends of each housing.
TECHNICAL OWNER MANUAL
B
A
NFINITY ASSEMBLY OF COMPONENTS
EN
14