Neo Specification - Rinnai Neo RIB2311N Installation Manual

Hide thumbs Also See for Neo RIB2311N:
Table of Contents

Advertisement

Neo specification
Natural draft burning log effect inbuilt gas fire
with glass front and convection fan. Different
frame options available.
Comes with an electronic timer remote, which lets
you preset the warmth to come on at any time.
Specification summary
Input
= 14-30 MJ/h*
Output
= 2.98-6.94 kW*
Efficiency
= 80%
Energy star
= 4.1 stars*
Heating area
= 69-107 m
Gas type
= NG or ULPG
* Will vary according to gas type and flue configuration
** Will vary depending on geographical location in NZ
Suitability
-
Inbuilt masonry
-
Inbuilt mock chimney
-
Freestanding
The Neo is not suitable for areas where painting
is taking place, or in places such as hairdressing
salons, where there may be fluff and dust, and
where aerosols are used. The inbuilt Neo gas
fireplace models are not designed to be built into
bookcases.
Installation considerations
The Neo draws air for combustion from the room.
Adequate ventilation must be calculated and
provided by the gasfitter as per AS/NZS 5601.1.
Burn media
Driftwood log set comes as standard.
Convection fan
Fan forced 2-speed convection fan (low and high).
Heat is distributed from the top of the appliance.
Data plate
Inside appliance on the front left hand side.
Gas connection
½ " BSPT. The gas supply terminates inside the
heater at the lower front right hand side of the
appliance.
Ignition
Continuous spark electronic ignition.
2
**
Noise level
37-45 dB(A)
Flue (masonry)
Rinnai recommends the use of a Rinnai flexiliner
flue (Ø 100 mm).
Flue (mock chimney and freestanding)
Inner 100 mm, outer 150 mm. Appliance must be
installed with a Rinnai flue system.
Power consumption and electrical supply
High
= 50 W
Standby
= < 3 W
Comes with a 1.5 m power cord and 3-pin plug.
The standard electrical connection is to the rear
left of the appliance, but can pass through the left
or right by removing the knockout tab from the
bottom edge of the front panel.
Safety devices
Overheat switch, electrical fuse, and flame failure
sensing system.
Temperature control
Thermostat control. Temperature control range
7-32 °C. The lower temperature range is for cooler
climates where the room temperature could fall
below 7 °C.
Weight
60 kg
Neo installation guide: 11906-I 09-17 | 5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Neo rib2311l

Table of Contents