Outer Frame And Dress Guard - Rinnai Neo Series Installation Manual

Outer frame and dress guard
Locate and remove the two frame assembly securing screws pre-positioned in the
mounting tabs in the heater engine body. These screws have been pre-inserted to
ensure correct threading of the frame securing tabs.
Attach the frame
Carefully pick up the outer frame assembly. Position the top fold over the frame assembly
mounting panel and gently push the lower edge of the frame assembly until it is flush at the
edges. Ensure you do not place excessive tension on, or pinch the communication cable when
moving the frame into position.
Fit and tighten the two frame retaining screws through the frame and frame mounting tabs on
the heater engine body.
Standard
frame
Tabs
Securing
screws
Classic frame: Attach the mesh dress guard
The mesh dress guard of the classic frame (inbuilt models only) is held in place by four slotted
tabs (two on each side) which lock into four slots on the front of the frame.
Slots
Slotted tabs
Top fold
Rear view
Classic
frame
Communication cable
Mounting panel
Neo RIB2312 installation guide: 12148-D 04-19 | 27