Masonry Installation - Rinnai Neo Series Installation Manual

Masonry installation
Prepare the site
1
Ensure the enclosure meets the dimension requirements and check the gas and electrical
supplies have been prepared according to information in this guide.
Unpack the engine
2
The Neo engine is supplied in one carton. Check for damage and ensure you have the
correct gas type before starting. Do not install if any damage is evident.
Install the flue
3
Install flexiliner flue*, refer following page and p. 32 for an overview of how the flue is
assembled and connected to the unit.
* As per AS/NZS 5263.0:2017 2.15.2.3, do not use an unlined masonry chimney as the flue for this appliance.
Prepare the engine
4
Attach the adhesive backed foam sealing strip supplied to the rear face of the front
assembly mounting panel, approximately 30 mm from the top edge. The foam seal forms a
seal between the unit and the fireplace brickwork. If a seal cannot be formed then another
means of sealing must be used—non-combustible insulation or heat resistant silicone.
Connect the flue adaptor
5
Connect the flue adaptor to the flexiliner flue.
Position the engine and connect the electrical supply
6
Place the Neo engine in front of the fireplace enclosure. Use a panel of cardboard packaging
underneath the engine to minimise damage to the floor. Connect the electrical supply.
Insert the Neo into the fireplace
7
Move the heater into the fireplace ensuring the gas supply pipe and fittings feed into the
rear access hole. Connect the flue.
Connect the gas supply
8
Refer p. 8.
Leak test
9
Leak test all appliance connections. When finished remove any residue with a rag, Prevent
any soapy solution coming into contact with the electrical components.
Secure
10
Fasten the heater to the fireplace using appropriate fasteners (not supplied), using the
three holes across the top and at least two holes on each side.
Complete the installation
11
Refer p. 22-28.
16 | Neo RIB2312 installation guide: 12148-D 04-19