Error Messages - Proceq ZDR 6020 Instruction Manual

11 Error messages

Error
6100
Carbox fan error
6110
Lamp fan blocked
6112
Lamp voltage error
6113
Lamp power error
6114
Chopper speed error
6116
CRio fan blocked
7110
Measuring head not
connected
7210
LAN connection not
available
7310
Data communication
error
7312
Sensor saturation
7420, 7422
State machine error
7501
GPS NL-404P serial
port error
7502
GPS Trimble serial
port error
7511
GPS NL-404P error
7515
GPS Trimble error
Description
Fan in power
supply unit is
blocked
Halogen lamp
fan is blocked
Lamp voltage is
out of range
Lamp power is
out of range
Chopper speed
is out of range
CRio vent is
blocked
Unable to
connect to the
measuring head
Ethernet
Controller not
active or no
power on
docking station
Data format
error
Too much light
on sensor
Cannot
measure
because lamp,
chopper or
FIFO is not OK
Cannot open
GPS serial port
Cannot open
GPS serial port.
No GPS Data
available
No GPS data
available
Page 66
Solution
Make sure the fan is not blocked
mechanically.
Make sure the fan is not blocked
mechanically. Remove cooling air inlet
and check visually if fan is blocked.
Make sure the measuring head is plugged
in correctly. Clean contacts on connector
plug with contact spray.
Make sure the lamp is not broken. Check
visually if the lamp is on. If not it might be
broken.
Make sure the chopper is not blocked.
Restart the system.
Make sure the fan is not blocked
mechanically. Restart the system.
Make sure the current NetSetMan profile
is set to ZDR 6020. Restart the system.
Check the LEDs at the network plug of the
docking station.
Check your network adapter and the
docking station's power cable.
Restart the system.
Adjust alignment of measuring head.
Restart the system.
Select the right COM port in the app
settings.
Select the right COM port in the app
settings.
Make sure the GPS sensor is connected
to the docking station.
Make sure the GPS antenna is plugged in
correctly in the power supply unit (car