Filter Settings:
Live Data Monitor:
DB Data Monitor:
Msre & RT Monitor:
Connection Monitor:
Calibration Monitor:
GPS Monitor:
State Machine:
Filter Settings
Before an R
value is calculated and displayed, the measured raw data need to
L
pass several filter and validation checks. Click on the "Filter Settings" tab in the
system configuration window:
Be aware that wrong filter settings may result in erroneous measurements.
The default values should not be changed.
Data filter needed to calculate R
Internal use only
Internal use only
Important system parameters like lamp voltage
Information about TCP parameters and active
connection.
Calibration parameters, internal use only
GPS, temperature and humidity
Internal use only
Page 42
L