No. of Markings Filter
Number of expected markings, value taken from the current Marking Preset, see
chapter 5.8.1 on page 37. Default = 1
DayContrastFilter
Calculation of day contrast ratio.
• DayContrast:
• ToleranceBandFromB.: Tolerance band in %, default = 10
Contrast Filter
Calculation of day contrast ratio.
• Contrast Threshold:
• Contrast Threshold.:
OffsetDifferenceFilter
Internal filter, do not change
AverageFilterSettings
Filter settings for average calculation of R
• PercentPassedMin.:
• CutFromTopForMean%: Percentage of the highest measurements to be
• TakeForMeanFromTop%: Percentage of measurements (counted from top) to
• RemovePeaksForMinMax: Enable / disable removal of peaks
CamTrigger
Filter settings for automatic camera triggering. Values taken from the current
Marking Preset, see chapter 5.8.1 on page 37.
• EnableAutoCamTrigger: Enable / disable filter
• CamTriggerMin:
• CamTriggerMax:
Msre & RT Monitor
Important system parameters like lamp voltage, signal quality and vehicle speed are
shown. Click on the "Msre & RT Monitor" tab in the system configuration window:
Enable / disable filter
Enable / disable filter
Contrast threshold, default = 2
(R
L
L
Min percentage of measurements within an interval
that must have passed all filters, default = 10
eliminated (noise reduction), default = 2
be included in average calculation, default = 20
Takes a picture if R
Takes a picture if R
Page 44
DB).
is lower, default = 100
L
is higher, default = 1000
L