General Settings - Proceq ZDR 6020 Instruction Manual

Settings Name:
Trigger Mode:
Average every:
Nr. of expected Markings: Number of markings that will be detected (1, 2 or 3)
Expected min width:
Expected max width:
R Pass/Fail min value:
L
R Pass/Fail max value:
L
Cam trigger low value:
Cam trigger high value:

5.8.2 General settings

The language can be changed in the general settings, click on "General" in the
settings window to open the general settings window:
Language:
Beep on Error:
GPS Model:
Name of the marking presetting
Automatic Meters (distance based, default) or
Automatic Seconds (time based for stationary wet
measurements). Indicates the distance or time
interval for calculating the average R
measurement file
Interval length (meter or seconds), depending on
the trigger mode.
Interval length in meter: 10 – 10.000 m
Interval length in seconds: 1 – 1.000 s
Minimum width of marking. Markings less wide will
not be measured (default: 80)
Maximum width of marking. Wider markings will not
be measured (default: 280)
Minimum R value of a marking, lower values will
L
be stored as 0 in the measuring file (default: 40)
Maximum R value of a marking, higher values will
L
be stored as 0 in the measuring file (default: 1000)
Picture will be taken if R
Picture will be taken if R
Language
Beep if error occurs
Trimble LAN (default)
Page 38
value in the
L
is lower
L
is higher
L