Installation and Wiring
6.6 Wiring the Terminal Block
Screw-type terminal blocks are used. The suitable wires are given below.
NOTE
•
When removing the wire's insulation, be careful not to scratch the core wire.
•
Do not twist the wires to connect them.
•
Do not solder the wires to connect them. The solder may break due to
vibration.
•
After wiring, make sure stress is not applied to the wire.
•
If the socket in the terminal block closes upon counter-clockwise rotation,
the connection is wrong. Disconnect the wire, check the terminal hole, and
then re-connect the wire.
Terminal block
Item
Number of pins
Manufacturer
Model
Product no.
Suitable wire
Size
AWG22
AWG24–16
90
OK
Description
9
Phoenix Contact Co.
MC1,5/9-ST-3,5
1840434
Cross-sectional area [mm
0.3
0.2–1.25
2
]
FPΣ User's Manual