Table of Contents
Advertisement
FP2 S−LINK Unit
4.1
Wiring Methods for S−LINK Main Unit
There are two method of wiring an S−LINK system standard wiring and loop wiring each
having its advantage.
The connections are described below. For detailed information, refer to the "S−LINK
Construction Manual."
4.1.1
Wiring to the S−LINK Terminal Block
The S−LINK terminal block is detachable. Wiring the S−LINK terminal block while it is
detached from the unit allows the wiring to be done without detaching the whole main
unit.
S−LINK unit
S−LINK terminal block
Terminal block: MC1.5/10−ST−3.5 (Made by Phoenix Contact Co.; provided as an
accessory)
The wires noted below should be used.
Suitable wiring
Size
Nominal cross−section surface area
AWG #20 to 16
0.5 to 1.25 mm
We recommend using the appropriate screwdriver to tighten the wiring.
S−LINK terminal
block
Appropriate screwdriver
2
S−LINK exclusive
flat cable
Power sup-
ply cable
Construction and Wiring
4.1 Wiring Methods for S−LINK Main Unit
next page
4 − 3
Advertisement
Table of Contents
