Panasonic FPS Series User Manual page 106

FPΣ User's Manual
Wiring method
The wire end can be directly crimped without removing the wire's insulation, saving labor.
After breaking off a contact from the carrier, proceed as follows:
Procedure
1. Insert wire without removing its insulation until it stops
2. Lightly grip tool
1
3. Insert press-fitted wire into connector housing
4. When all wires have been inserted, fit semi-cover into place
NOTE
•
If there is a wiring mistake or the cable is incorrectly pressure-connected,
the contact puller pin provided with the fitting can be used to remove the
contact.
Press the housing against the pressure connection tool so that the contact puller pin comes in
1
contact with this section.
2
6.5 Wiring the MIL Connector
89