Panasonic FPS Series User Manual page 35

CPU Types
The factory settings are shown below. They can be changed in the system registers.
Communication parameter
Baud rate
Data length
Parity
Stop bit
Set the station number for the TOOL port in the TOOL port setting area of the system
registers.
Input connector
5
Input status LEDs
6
Output connector
7
Output status LEDs
8
Analog potentiometer (analog dial)
9
Not available for CPU types with thermistor input (part number ends in TM).
Turning the potentiometers changes the values of the special data registers reserved for the
potentiometer input. The values can be set within a range of 0-1000.
Using the potentiometers, you can change the internal set values in the PLC (e.g. of an
analog clock) without needing the programming tool. See also "Analog Potentiometer" on
page 29.
10
Power supply connector (24V DC)
Use the power supply cable provided. Product no.: AFPG805
11
Connector for FPΣ I/O expansion units
Connects a dedicated FPΣ expansion unit on the left side of the CPU to the internal circuit.
12
Station number setting switch
The station number setting switch is located under the cover labeled "EXPANSION
CONNECTOR" on the left side of the CPU. Specify the station number using the selector
switch and the dial.
The station number must be specified when using the communication functions provided by
the optional communication cassettes. The station number of the TOOL port cannot be
18
Factory settings
9600bit/s
8
Odd
1bit
FPΣ User's Manual