Wiring The Communication Cassette - Panasonic FPS Series User Manual

Installation and Wiring

6.7 Wiring the Communication Cassette

The communication cassette is supplied with a communication connector, which has a screw-
type terminal block.
NOTE
•
When removing the wire's insulation, be careful not to scratch the core wire.
•
Do not twist the wires to connect them.
•
Do not solder the wires to connect them. The solder may break due to
vibration.
•
After wiring, make sure stress is not applied to the wire.
•
If the socket in the terminal block closes upon counter-clockwise rotation,
the connection is wrong. Disconnect the wire, check the terminal hole, and
then re-connect the wire.
•
If two wires are connected to the plus and minus terminals of the RS485
port of FPG-COM4, use wires of the same cross-sectional area (0.5–
0.75mm
Accessory communication connector
If additional connectors are needed, use the communication connector manufactured by
Phoenix Contact.
Item
Number of pins
Manufacturer
Model
Product no.
92
OK
2
).
Description
5
Phoenix Contact Co.
MC1,5/5-ST-3,5
1840396
FPΣ User's Manual