Mewtocol-Com Error Codes - Panasonic FPS Series User Manual

FPΣ User's Manual

12.7.3 MEWTOCOL-COM Error Codes

Error
Name
code
!21 NACK error
!22 WACK error
!23 Unit no. overlap
!24 Transmission format error
!25 Link unit hardware error
!26 Unit no. setting error
!27 No support error
!28 No response error
!29 Buffer closed error
!30 Time-out error
!32 Transmission impossible error
!33 Communication stop
!36 No destination error
!38 Other communication error
!40 BCC error
!41
Format error
!42 No support error
!43 Multiple frames procedure error
!50 Link setting error
!51 Transmission time-out error
!52 Transmit disable error
!53 Busy error
!60 Parameter error
!61 Data error
!62 Registration over error
!63 PC mode error
!64 External memory error
!65 Protect error
Description
Link system error
A transfer error occurred in the data received.
A formatting error in the command received was detected.
A non-supported command was received.
A different command was received when processing multiple
frames.
A non-existing route number was specified. Verify the route
number by designating the transmission station.
Transmission to another device is not possible because the
transmission buffer is full.
Transmission processing to another device is not possible (link unit
runaway, etc.).
Processing of command received is not possible because of
multiple frame processing or because command being processed
is congested.
Content of specified parameter does not exist or cannot be used.
There was a mistake in the contact, data area, data number
designation, size designation, range, or format designation.
Operation was done when number of registrations was exceeded
or when there was no registration.
PC command that cannot be processed was executed during RUN
mode.
An abnormality occurred when loading RAM to ROM/IC memory
card. There may be a problem with the ROM or IC memory card.
When loading, the specified contents exceeded the capacity. Write
error occurs.
• ROM or IC memory card is not installed.
• ROM or IC memory card does not conform to specifications
A program or system register write operation was executed when
the protect mode (password setting or DIP switch, etc.) or ROM
operation mode was being used.
12.7 Error Codes
301