AT&T Network Adapter 25 Installation And Maintenance Manual page 215

ERROR MESSAGE
AND DESCRIPTION
Invalid Message Length:
CP sent an up-link message that
is not in the expected message
set.
Invalid Port Board:
CPU or Memory) Port CP not
supported by system.
Invalid Port Message:
CP sent an up-link message that
is not in the expected message
set.
LAN
Protocol Error:
Interface CP) This error may be
caused by a defective endpoint on
the STARLAN NETWORK.
Limited Default Cold Start: This is
a cold start after which only a
limited a m o u n t o f
translations have been made. The
CPU/Memory, Service Circuit, and
Tone Detector are the only CPs
initialized.
Memory Management Corruption:
Software audit determined and
corrected memory management.
The port If the problem persists, check or
replace the port CP.
Remove or replace CP with a
(Other than
board that is supported by System
25.
The port If problem persists, check or
replace the port CP.
(STARLAN System will normally recover;
however, if the problem persists,
a defective endpoint may exist on
the STARLAN NETWORK (see
Figure 4-5).
Connect
system.
default System" procedure listed in the
Administration Manual.
If problem persists, check or
replace CPU/Memory CP.
MAINTENANCE
POSSIBLE SOLUTION
S A T a n d translate
Perform "Restore
4-39