AT&T Network Adapter 25 Installation And Maintenance Manual page 218

MAINTENANCE
ERROR MESSAGE
AND DESCRIPTION
Port CP Missing
"Administered:
CPU/Memory) Translated port CP
that CPU cannot access.
Port CP Out Of Service: (Other
than CPU/Memory)
occurs when a CP is removed
from a cabinet. Error removed
when the CP passes power-up.
Port CP ROM Checksum Failure:
The port CP has found that the
checksum on its firmware is bad.
Port Buffer Full:
Interface CP) This error resets the
C P .
Port Fault: For an auxiliary trunk,
this message is logged when a
ground is expected from external
equipment and is not detected.
Port Queue Full:
Interface CP) This error resets the
C P .
Program L o g i c Inconsistent:
t h a n
( O t h e r
Possible hardware problem on
port CP.
RAM Test Failed: CPU/Memory
CP has failed the RAM test.
4-42
B u t
Check CP slot; reseat CP; change
(Other than CP;
translations. If CP does not pass
power-up, replace CP.
If the CP has not been removed
Message and the problem persists, check
or replace the port CP.
Try reseating the CP. If this error
happens again, then replace the
C P .
(STARLAN If the reset is not successful,
reseat CP. If the reseat fails,
replace the CP.
C h e c k
equipment (see Figure 4-7).
If the reset is not successful,
(STARLAN
reseat CP. If the reseat fails,
replace the CP.
Reseat CP. If problem persists,
CPU/Memory) replace it.
Check CPU/Memory CP.
POSSIBLE SOLUTION
or remove C P f r o m
wiring of external