Verifying Translations - AT&T Network Adapter 25 Installation And Maintenance Manual

MAINTENANCE
Press c to continue, and the tape unit is automatically started by the
system. Saving translations on tape takes about 5 minutes and does
not affect switch performance.
When the save is complete, the unit stops automatically.
If the save is successful, the SAT displays:
SAVE COMPLETED SUCCESSFULLY.
9. Press the REWIND button and rewind the tape fully.
10. Verify the translations saved on the tape, following the steps in the
next procedure.

Verifying Translations

Always verify the translations saved to tape because of the possibility of
faults with cassettes or equipment. Successful completion of the Verify
function assures that saved translations match exactly the translations in the
s y s t e m .
N o t e : Performing the Verify function takes about 5 minutes.
To verify translations saved to tape, follow these steps:
1. Complete the steps under "Setting Up the DTU" unless Verify is
being performed immediately after the Save function.
Press the PLAY button on the tape unit. (The unit should not yet
2.
begin to run.)
Log on to the SAT, if not already logged on.
3.
The system displays the main menu prompt:
Make one selection from menu ->.
Enter 9 for the SAVE/RESTORE selection.
4.
The system responds with:
>Action=.
4-16