Table of Contents
Advertisement
2. To create a new interface group, enter a unique
below.
3. If this new grouped interface is to share the WAN interface, click
cause the WAN interface you select to be removed from any other interface groups.
Important:
If a vendor ID is configured for a specific client device, make sure to reboot the client device attached to the gate-
way to allow it to obtain an appropriate IP address.
4. In the
Available WAN Interfaces
Grouped WAN Interfaces
Note: Depending on the WAN interface configuration, these clients may obtain public IP addresses.
5. Do the same in the
Grouped
6. To automatically add LAN clients (such as set-top boxes) to a WAN Interface in the new group, enter the
string. You can add up to 16 vendor IDs.
When you configure a DHCP vendor ID string, any DHCP client request that includes this vendor ID is denied an IP address
from the local DHCP server (DHCP option 60).
7. Click Apply/Save. Your changes take effect immediately.
8. To remove a grouping, select the grouping and click Remove. You can only remove groupings that you create.
IP Tunnel
IP Tunneling is typically used as a means to establish a path between two independent networks. Your SmartRG gateway supports
connecting islands of IPv6 networks across the IPv4 internet or IPv4 in IPv6 as well.
In this section, you can configure IP tunnel settings.
Note: For IPv6inIPv4, only 6rd configuration is supported. For IPv4inIPv6, only DS-Lite configuration is supported.
IPv6inIPv4
On this page, you can configure the IPv6inIP4 settings.
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2019
Group
list, select the interface(s) that you want to group and click the left arrow to move it to the
list. Hold down the CTRL key or Shift key to select multiple interfaces.
and
Available LAN Interfaces
Name, then proceed with either step 3 (dynamic) or step 4 (static)
Shared WAN
Interface. Not selecting this option this will
lists for any applicable LAN interfaces.
DHCP vendor ID
87
Advertisement
Table of Contents
