Table of Contents
Advertisement
Field Name
Description
Select Scheduler for
Select an algorithm for applying queue data priority. Options are:
Queues of Equal Pre-
l
cedence as the
Default Queue
l
Enter a default weight of the specified queue. Options are 1 - 63 .
Default Queue
Weight
Enter a precedence for the specified queue. Options are 1 - 8 .
Default Queue Pre-
cedence
Enter the default minimum rate at which traffic can pass through the queue. Kbps. Options are 1
Default Queue Min-
- 0 Kbps.
imum Rate
Enter the shaping rate for the specified queue. Options are 1 - 0 Kbps.
Default Queue Shap-
ing Rate
Enter the maximum rate at which traffic can pass through the queue. Options are 1600 bytes or
Default Queue Shap-
ing Burst Size
greater.
ETH Interface
If you are using a gateway that is Ethernet-specific (non-DSL), you may want to configure an ETH interface to manage communication.
Most models support Ethernet and can be configured for Ethernet and DSL at the same time. Your gateway has four LAN ports. One
of them can be re-purposed to become an RJ45 WAN port when needed.
On this page, you can configure an Ethernet interface for your gateway.
1. In the left navigation bar, click
2. If no WAN port is configured, the
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2019
latency.
Weighted Round Robin: Time slices are assigned to each process in equal portions and in
circular order, handling all processes without priority (also known as cyclic executive).
Weighted Fair Queuing: A data packet scheduling technique allowing different schedul-
ing priorities to be assigned to statistically multiplexed data flows. Since each data flow
has its own queue, an ill-behaved flow (that sent larger packets or more packets per
second than the others since it became active) will only affect itself and not other ses-
sions.
Advanced Setup
>
Layer2 Interface
Add
button appears. Click Add.
>
ETH
Interface.
28
Advertisement
Table of Contents
