Table of Contents
Advertisement
Security
In this section, you can configure filtering for IP and MAC.
IP Filtering - Outgoing
On this page, you can add an outgoing filter when refusal of data from the LAN to the WAN is desired.
1. In the left navigation bar, click
2. Fill in the fields, using the information in the table below.
3. Click
Apply/Save
to commit the completed entry.
The fields on this page are explained in the following table.
Field Name
Description
Filter Name
Enter a descriptive name for this filter.
IP Version
For the filter to be configured and effective for IPV6 , the gateway must be installed on a network
that is either a pure IPV6 network (with that protocol enabled) or is both IPV4 and IPV6 dual protocol
enabled/configured. Options are IPv4 and IPv6 . The default is IPv4 .
If you select IPV6, both the Source and Destination IP addresses must be specified in IPV6 format. The
following is an IPV6-compliant, hexadecimal address: 2001:0DB8:AC10:FE01:0000:0000:0000:0001.
Protocol
Select the protocol profile for the filter you are defining. TCP/UDP is most commonly used. The
options are TCP/UDP , TCP , UDP , and ICMP ].
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2019
Advanced Setup
>
Security
and then click Add. The following page appears.
61
Advertisement
Table of Contents
