Table of Contents
Advertisement
Field Name
Default Queue Precedence Enter a precedence for the specified queue. Options are: 1-8.
Default Queue Minimum
Rate
Default Queue Shaping
Rate
Default Queue Shaping
Burst Rate
ETH Interface
On this page, you can configure an Ethernet interface for your gateway.
Note: If a WAN port is already configured, you must remove it before you can define a new one. The
until the existing port is removed. Modify or delete any WAN service that uses it. Then, return to this page and click the
checkbox and then click the
Remove
1. In the left navigation bar, click
lowing page appears.
2. Click Add.
3. If a WAN port is already configured or you clicked Add, the following page appears.
Note: If a port is already configured, you must remove it before adding a new one. Click the
the
Remove
button.
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2020
Description
The default minimum rate at which traffic can pass through the queue. For no shaping,
enter -1 (disabled). Options are: 1-0 Kbps.
The shaping rate for the specified queue. Options are: 1-0 Kbps. The default is -1 (no
shaping).
The maximum rate at which traffic can pass through the queue. Options are 1600 or
greater.
button.
Advanced Setup
>
Layer2 Interface
>
ETH
Interface. If no WAN port is configured, the fol-
Add
button does not appear
Remove
Remove
checkbox and then click
29
Advertisement
Table of Contents
