Table of Contents
Advertisement
Preparing Superdome for Booting
Unpacking and Installing the Blower Housings and Blowers
Step 4. Using the handles on the housing labeled Blower 0 Blower 1, part number A5201-62030, align
the edge of the housing over the edge at the top front of the SPU cabinet, and slide it into place
until the connectors at the back of each housing are fully mated; then tighten the thumbscrews at
the front of the housing.
Figure 3-4Installing the Front Blower Housing
Step 5. Unpack each of the four blowers.
34
60IN003A
10/27/00
Chapter 3
Advertisement
Table of Contents
