There are three thumbscrews: two secure the CMA to the back of the rack and one secures the arm
to the rack slides. See figure below:
Figure A-6 hp Server rx2600 Cable Management Arm
Fastens to rack slide
Fastens to back of rack
Installing the Tape Array 5300A
I/O for the hp Server rx2600 is installed in the Tape Array 5300 chassis. Perform the following procedure.
Step 1. Install each storage unit into the Tape Array 5300 by sliding it into the appropriate slot.
The correct configuration is:
•
DVD drive in slot 1
•
DAT drive in slot 3
Ensure that the storage unit back connector engages with its mating chassis connector and pull up
the locking mechanism on the left of the storage unit.
Step 2. Mount the Tape Array 5300 rack shelves into the rack following the supplied installation procedure
and using the supplied rack mounting hardware.
Appendix A
hp Server rx2600 Support Management Station
Installing the hp Server rx2600 SMS
135