Table of Contents
Advertisement
Unpacking the SMS, Connecting Cables, and Setting SCSI Addresses
Connecting SCSI Cables and Setting SCSI Addresses on the Support Management Station
Connecting SCSI Cables and Setting SCSI Addresses on the Support
Management Station
After the Support Management Station (SMS) components have been removed from their packaging and have
either been placed in a rack or stacked together on a table, install the SCSI cables and set the SCSI
addresses.
NOTE
Make sure all devices on the SCSI bus have a unique address and that the last device is
terminated. Refer to the documentation accompanying each device to learn where to place
terminators.
To connect the SMS peripherals and set SCSI addresses:
Step 1. Connect the cables between the SMS, DDS tape drive, and DVD.
Figure I-1Connecting DDS Tape and DVD/CD-ROM Drives to SMS
Step 2. Connect the power cables, one for each peripheral and one for the SMS.
Step 3. Set the SCSI ID of the DDS tape drive to 1 and the SCSI ID of the DVD to 2.
The hard drive is preset to 6, and 5 is available for another internal SCSI device.
Refer to the documentation accompanying each device to learn how to set SCSI addresses.
236
A-Class Server
Address 6 Address 5
2.0 meter
SCSI Cable
DDS
DVD
Address 1
Address 2
0.5 meter
SCSI Cable
Appendix I
Advertisement
Table of Contents
