Connecting the Cabinets
After preparing Cabinets 0 and 1, you are ready to connect them.
Installing the Rear Attachment Brackets
To install the rear attachment brackets:
Step 1. Orient the attachment brackets (A52201-00241) so that the countersunk side faces out.
Step 2. Using a T30 Torx driver, install each bracket using the flathead screws (0515-3210) provided in
this kit.
Figure G-7Installing the Rear Attachment Brackets
Flathead Screws
In All 8 Locations
Installing the Front Attachment Brackets
This section describes how to install the front attachment brackets. Unlike the rear attachment bracket
procedure, it is not necessary to remove the door and hinge at the front of the cabinet. To install the front
attachment brackets:
Step 1. On Cabinet 1, loosely install four (4) pan head screws (0515-0441) through the holes in the hinge,
two for each attachment bracket. Refer to Figure G-8, Step 1.
Appendix G
Cabinet Attachment
Brackets
Connecting Multiple SPU Cabinets
Connecting the Cabinets
60IN085A
12/5/00
189