Remote Configuration And Control; Introduction To Sis; Error Messages - Extron electronics DTP2 T 201 D User Manual

Remote Configuration and
Control
This section describes remote operation of the DTP2 T 201 D by using Simple Instruction
Set (SIS) commands to control the DTP2 T 201 D transmitter. In addition this section
provides information about updating your device to the latest firmware.
The following topics are discussed:
•
•
•
•

Introduction to SIS

The DTP2 T 201 D transmitter accept SIS commands from a host device such as a
computer running the Extron DataViewer utility or other control system. The host device
can be connected to the Config port on the bottom panel (see
Panel USB Port
SIS commands consist of strings (one or more characters per command field). Upper and
lower case characters can be used interchangeably. Commands do not require any special
characters to begin or end the command string. Each response from the DTP2 T 201 D
transmitter ends with a carriage return and a line feed (CR/LF =
of the response character string.
When the transmitter is first switched on, it sends the message:
(c) Copyright 20xx, Extron Electronics DTP2 T 201 D, Vx.xx 60‑xxxx‑xx

Error Messages

E10
E13
Introduction to SIS
Symbols Used in this Guide
Command and Response Table for SIS Commands
Downloading and Updating Firmware
on page 13).
is the firmware version number.
• Vx.xx
• is the part number of the device.
60‑xxxx‑xx
— Invalid command
— Invalid parameter
DTP2 T 201 D Transmitter • Remote Configuration and Control
Connecting to the Bottom
]
), which signals the end
]
16