Table of Contents
Advertisement
Semi-Automatic Operation
If desired, you may override the
automatic control system and operate
some features manually (such as fan
speed and air distribution). Manually
selecting such features when in 'AUTO'
mode changes the system to 'Semi-
Auto'. Full automatic control can be
resumed at any time by pressing the
'AUTO' button. Optimum comfort can be
best achieved in 'AUTO' mode.
Dual-Zone Temperature Control
Dual-zone temperature control allows
the driver and front passenger to set
independent air temperatures according
to personal preference.
_
The temperature may be adjusted for
each side by pressing the temperature
control button in the appropriate
direction until the desired temperature is
achieved.
The selected temperature for either side
is displayed on the corresponding side of
the SYNC
screen. The temperature for
®
either side can be set between the range
of 18°C and 30°C, in 0.5°C increments.
If a temperature below 18ºC is selected,
then 'LOW' is displayed. If a temperature
above 30ºC is selected, then 'HIGH' is
displayed.
The automatic temperature control may
be overridden by selecting 'H' (HIGH) or
'C' (LOW) from the driver temperature
setting button. This action will cause the
passenger set temperature to match the
driver's selection of 'H' or 'C'.
Climate Control
Note: Cabin comfort level may not be
maintained when 'H' or 'C' is selected for
extended periods.
Dual-Zone Temperature
Linking
Dual-zone temperature control
linking occurs when the passenger
temperature automatically follows the
driver's temperature setting.
Linking is activated by any one of the
following conditions:
•
Pressing and holding the 'AUTO'
hard button below the air register,
for at least two seconds.
•
If the driver and passenger
temperature settings are identical
prior to switching the ignition key
+
'OFF'.
Dual-Zone Temperature
Unlinking
The passenger may unlink the
temperature setting at any time by using
the passenger temperature control
button.
Note: The rear-console vent outputs
correspond to all climate control panel
outputs as set by the driver or front
passenger.
Note: The heater maintains warmth
only when the engine is operating. Full
heating is only available when the engine
is at normal operating temperature.
-95-
_
+
Advertisement
Table of Contents
