Table of Contents
Advertisement
Rear Licence Plate Lamps
1.
Carefully insert a flat blade under
one side of the lamp assembly.
2.
Press gently on the locking tab.
3.
Lift the lamp assembly out of the
licence plate trim.
4.
Disconnect the wiring connector.
5.
Turn the bulb holder approximately
one eight turn anti-clockwise until it
is free.
6.
Pull the bulb from the socket.
7.
Replace the bulb and bulb holder
and connect the wiring connector.
8.
Push the lamp assembly into the
licence plate trim until the locking
tabs engage.
Lighting
Sun Visor Vanity Mirror Lamp
(if equipped)
1.
Carefully unclip the lens from the
bezel using a screwdriver on the
end of the lens opposite the knob.
2.
Remove the bulb from the lamp.
A
3
AUS03321
3.
Install the bulb into the lens.
4.
Refit the lens into the bezel, inserting
the knob-end first.
-58-
1
Section A - A
A
2
Advertisement
Table of Contents
