Table of Contents
Advertisement
BOOSTER (JUMP)
STARTING
WARNINGS
Jump starting could be dangerous
if done incorrectly. Therefore, if the
following conditions cannot be met, or if
you are uncertain about them, we
strongly recommend that you leave the
procedure to a competent mechanic or
towing service.
Do not attempt a jump-start if the
discharged battery is frozen or if
the battery fluid level is low, as the
battery may rupture or explode.
Flames, sparks or lit cigarettes can
cause the gases around the
battery to explode, causing injury and
damage. Keep these things away from
the battery.
Ensure the battery to be used for
boosting is 12V and that the
negative terminal is grounded. If
instructions are not observed, damage
to electronic components may result.
To protect yourself when charging
a battery, always shield your face
and eyes. Ensure proper ventilation and
that you can breathe fresh air.
Do not let children touch the
battery.
Batteries contain sulphuric acid
which burns skin, eyes and
clothing. If the acid touches someone's
skin, eyes or clothing, immediately flush
the area with water for at least fifteen
minutes. If someone swallows the acid,
call a doctor immediately.
Vehicle Battery
Booster Lead Connecting
Procedure
Remove the filler vent caps from both
batteries and place a damp cloth over
the batteries. If the booster battery is
installed in another vehicle, do not allow
the two vehicles to touch. Turn off all
unnecessary electrical loads. Firmly apply
the park brake on both vehicles and
select neutral gear (manual transmission)
or Park (automatic transmission).
-
1.
Connect the red lead to the positive
(+) terminal of the discharged
battery.
2.
Connect the other end of the same
red lead to the positive (+) terminal
of the booster battery.
3.
Connect the black lead to the
negative (-) terminal of the booster
battery.
4.
Connect the other end of the same
black lead to the engine of the
vehicle with the discharged battery.
discharged battery.
metal on either vehicle, and are clear of
the cooling fans and drive belt.
-191-
+
+
WARNINGS
Do not connect the lead to the
negative terminal of the
Take care that the jumper clamps
do not touch each other or any
-
+
Advertisement
Table of Contents
