If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step. NOTE: Make sure to use the latest scan tool software release. If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC). 2011 Mustang, 2/2011...
• Compass calibration • Compass module (integral to the auto- dimming interior mirror) Pinpoint Tests Pinpoint Test A: The Compass Is Inoperative Refer to Wiring Diagrams Cell 124 Power Mirrors for schematic and connector information. Normal Operation 2011 Mustang, 2/2011...
Page 4
OK. If OK, REPAIR the circuit. TEST the system for With camera mirror C9039-1 Ground normal operation. If not OK, REFER to the Wiring CBP41 (BU) Diagrams Manual to identify the possible causes of the circuit short. 2011 Mustang, 2/2011...
Page 5
Without camera C911-3 Ground mirror, without SYNC GD139 (BK/YE) Without camera C9012-10 Ground mirror, with SYNC GD139 (BK/YE) GO to A4. With camera mirror C9039-3 Ground GD139 (BK/YE) REPAIR the circuit. TEST the system for normal operation. 2011 Mustang, 2/2011...
Page 6
Ground VMC31 (GY/BU) Without camera C9012-2 Ground mirror, with SYNC VMC30 (BU/GY) C9012-6 Ground REPAIR the circuit in question. TEST the system for VMC31 (GY/BU) normal operation. With camera mirror C9039-10 Ground VMC30 (BU/GY) GO to A6. 2011 Mustang, 2/2011...
Page 7
Without camera C9012-6 C220-10 mirror, with SYNC VMC31 (GY/BU) VMC31 (GY/BU), then ground GO to A7. With camera mirror C9039-9 C220-10 VMC31 (GY/BU) VMC31 (GY/BU), then ground REPAIR the circuit. CLEAR the DTCs. REPEAT the self-test. 2011 Mustang, 2/2011...
Page 8
Without camera C9012-2 C220-9 mirror, with SYNC VMC30 (BU/GY) VMC30 (BU/GY), then ground GO to A8. With camera mirror C9039-10 C220-9 VMC30 (BU/GY) VMC30 (BU/GY), then ground REPAIR the circuit. CLEAR the DTCs. REPEAT the self-test. 2011 Mustang, 2/2011...
When calibrated correctly, the compass module (integral to the auto-dimming interior mirror) provides vehicle directional inputs to the Instrument Panel Cluster (IPC) which sends the compass information to the FDIM over the Medium Speed Controller Area Network (MS-CAN). The FDIM displays the vehicle heading based on the selected zone setting. 2011 Mustang, 2/2011...
Page 10
Dimming Interior Mirror in Section 501-09. SET the zone. REFER to Compass Zone Adjustment in this West section. CALIBRATE the compass. REFER to Northwest Compass Calibration in this section. TEST the system • Does the compass display correctly for each direction? for normal operation. 2011 Mustang, 2/2011...
Need help?
Do you have a question about the ST3093-A and is the answer not in the manual?
Questions and answers