Ford FG X FALCON SEDAN 2015 Owner's Manual page 40

Note: In this mode, the unlock button in
the ICC is also disabled when the ignition
is switched off.
Replacement / Additional
keypads
Up to a maximum of eight keypads can
be trained to your vehicle. Replacement/
additional keypads are available from
your authorised Ford dealer.
To Train Keypads
Note: Old keypads are removed from
the system memory during the training
procedure. Ensure all keypads are
available to be retrained at the same
time (old and new).
1. Switch the ignition from the 'OFF' to
the 'ACC' position.
2. Press the rear window demister
button three times within five
seconds. The door locks cycle to
indicate that the system is in training
mode.
3. Press any button on the keypad to
be trained. The door locks cycle to
indicate that the keypad has been
trained.
Note: Frst keypad trained results in one
door lock cycle; second keypad trained
results in two-door lock cycles, etc.
4. Repeat step 3 for all other keypads
to be trained. Turn the ignition 'OFF'.
The door locks cycle to indicate that
the training mode has been exited.
Replacement Batteries
If the range of the transmitter in the
key decreases gradually, replace the
battery.
Locks and Security
push tool parts inside the body of the
remote control or damage to the internal
circuits may occur. Keep the old battery
out of reach of children and dispose of
responsibly. If in any doubt, your Ford
dealer will be happy to change your
battery for you.
Flip Key Battery Replacement
1.
2.
3.
-38-
WARNING
Take care when using hand tools
to avoid personal injury. Do not
Press the release button to flip the
key blade to the open position.
Insert a thin screwdriver as far as
possible into the second slot from
the base of the key and push it
towards the key blade to release the
container from the key blade.
Separate the key blade component
from the keypad container.