Wipers And Washers; Wiper And Washer Controls - Ford FG X FALCON SEDAN 2015 Owner's Manual

WIPER AND WASHER
CONTROLS
Note: Ensure the windshield wipers are
switched off before entering a car wash.
Note: Do not operate the wipers on
a dry windshield.This may scratch the
glass, damage wiper blades or cause the
wiper motor to burn out. Always use the
windshield washers before wiping a dry
windshield.
Note: Clean the windshield and wipers if
they begin to leave streaks or smears. If
that doesn't resolve the issue, install new
wiper blades.
Note: Wet road conditions can cause
unexpected wiping or smearing when
auto wiper is enabled.
The following functions are available with
the ignition switch in the 'ACCESSORY'
or 'ON' positions.
Wash/Wipe
Pull the lever towards the steering wheel
for more than 0.5 seconds. The wipers
and washers activate to clear the screen.
Single Wipe
Momentarily push the lever up.

Wipers and Washers

Speed Sensitive, Variable
Frequency Intermittent Wipe
(INT) (if equipped)
With the ignition switch in the 'ON'
position, the delay between wipes varies
with vehicle speed. As vehicle speed
increases, the time delay between wipes
decreases. This feature also includes
a single wipe which is activated when
the vehicle speed reaches 8 km/h in a
forward direction.
1.
2.
3.
Low Speed Wipe (1)
Push the lever down to the second
detent position.
High Speed Wipe (2)
Push the lever down to the third detent
position.
-47-
Push the lever down to the first
detent position.
Rotate the control clockwise
(toward the small end of the wedge
symbol) to decrease the time delay
between wipes.
Rotate the control counter-
clockwise (toward the large end of
the wedge symbol) to increase the
time delay between wipes.