Ford FG X FALCON SEDAN 2015 Owner's Manual page 80

When set to 'OFF', the illumination is
controlled by the lamps 'ON' state.
'AUTO' lamps illumination is always
controlled by the sensor.
Climate Display
Toggles pop-ups for climate information.
When set to 'ON', the cluster provides
an indication of a change to the climate
control system. This indication is in the
form of a pop-up screen that indicates
the status of the climate control system.
This pop-up screen provides the user
with information regarding the status of
the following items of the climate control
system:
• Climate mode: 'OFF', Face, Floor,
Face and Floor, Screen, Screen and
Floor or Auto.
• Rear demist: 'ON' or 'OF'F.
• Air recirculation or fresh air.
• Air conditioning: 'ON' or 'OFF'.
Locking
Drive-Away Locking
When the ignition is on, drive-away
locking locks all doors when the vehicle
speed exceeds 12 km/h and the driver
or passenger door is unlocked.
This can be manually overridden at any
time using the door locks or the central
unlock, but reactivates when the vehicle
speed exceeds 12 km/h.
Press the 'SEL' button to select or
deselect drive-away locking.
A tick appears on the MFD screen to
highlight your selection.
Instrumentation
Lock Confirm with Indicators
'Lock Confirm with Indicators' flashes
the indicators twice when the vehicle is
locked using the remote key.
Press the 'SEL' button to select or
deselect the 'Lock Confirm with \
Indicators'
Lock Confirm with Horn
'Lock Confirm with Horn' sounds the
horn when the vehicle is locked using the
remote key.
Press the 'SEL' button to select or
deselect the 'Lock Confirm with Horn.'
Boot Lock
Once the ignition it turned off and locked,
this disables the 'Unlock' button in the
Interior Command Centre (ICC), and
dsables the boot buttons.
For more information on unlocking,
please refer to the 'Locks and Security'
section of this manual.
Default Locking Settings
The 'Default Locking Settings' restores
the factory default settings for the
locking menu items.
'Default Locking Settings' can only
be selected if the configuration of the
locking settings deviates from the
default.
Press the 'SEL' button to select 'Default
Locking Settings'.
-78-