Table of Contents
Advertisement
•
Push down rear of switch to move
rear of seat base down.
•
Lift up front of switch to move front
of seat base up.
•
Push down front of switch to move
front of seat base down.
Driver Seat and Exterior
Mirrors Memory (if equipped)
The seat memory system enables five
driver seat and exterior mirror positions
to be programmed and recalled. Two of
these positions are stored and recalled
through the remote keypads, and an
additional three manual positions can
be programmed and selected using the
buttons on the side of the seat.
Storing Memory Positions
To store a memory position on the
seat-mounted memory position buttons
one, two or three, put the key in 'ACC'
position and set the seat and mirror
positions as required.
Press and hold a preset button for
two seconds. A double chime sounds
Seats
confirming memory storage.
Note: Seat memory recall is disabled
when the ignition is in the 'ON' position.
Each of the two remote keypads can
store one setting for seat and mirror
positions. When using the remote
keypad to unlock and enter the vehicle,
any position changes then made to
the seat, mirrors or mirror dip on/off
enabled status can be recalled and
then automatically saved to that remote
keypad upon locking.
Recalling Memory Positions
Memory positions can be recalled by
either:
SEAT
MEMORY
1
2
3
1.
Briefly pressing one of the three
memory buttons located on the
seat base. A single chime sounds
indicating position has been recalled.
2.
Entering the vehicle using one of the
two programmed remote keypads.
The two remote keypads can each
have an individual setting.
-99-
Advertisement
Table of Contents
