Table of Contents
Advertisement
3.
Remove the bulb holder by turning
anti-clockwise 45 degrees.
4.
Remove the bulb from the holder by
pulling straight out.
5.
Replace the bulb and bulb holder.
6.
Secure the splash shield.
Side Repeater - External
Mirror Mounted (if equipped)
CAUTION
It is recommended that this
procedure is carried out by your
authorised Ford dealer.
Daytime Running Lamps
(if equipped)
The Daytime Running Lamps (DTRLs) are
part of the headlamp functionality. They
improve vehicle visibility during daylight
environments, thereby improving road
safety conditions.
These LED lamps turn on as soon as you
turn on the ignition. During night-time or
low-ambient light, when you turn on the
parking lamps, the DTRLs take over the
parking lamp functionality.
Front Fog Lamps (if equipped)
1.
Switch off the lights and allow to
cool.
2.
Disconnect the wiring loom plug at
the connector socket.
3.
Rotate the H11 bulb assembly
through a quarter turn anti-
clockwise, then pull.
Lighting
Hold the replacement Quartz
Halogen bulb with a clean cloth or
tissue to prevent contact with glass. If
the glass is touched, the skin's natural
oils will contaminate the bulb. If touched,
wipe the bulb clean using methylated
spirits before installing.
Rear Lamps
There are two rear lamps - body-side
lamp and boot-lid lamp.
•
Body-side lamps have a direction
indicator, brake lamp and position
lamp.
•
Boot-lid lamps have a reverse lamp
and a position lamp.
Set out below are the procedures for
bulb replacement for the two sections.
Body-side lamp:
1.
Open the boot lid.
2.
Remove the scrivet and pull back
the boot trim to reveal the three nuts
retaining the light assembly cluster.
3.
Remove the three retaining nuts.
-56-
CAUTION
H11 LL
Advertisement
Table of Contents
