Table of Contents
Advertisement
Installing the Zone Ctrl II
Installing the Zone Ctrl II
1
Mount the controller (page 6).
2
Wire the controller for power (page 10).
3
Set the controller's address (page 12).
4
Wire the controller to the BACnet MS/TP or BACnet ARC156 network (page 15).
5
Wire inputs and outputs. (page 16)
6
Wire devices to the controller's Rnet port (page 19).
For details on installing a secondary terminal, see Using a VAV Zone II Secondary Duct for a dual duct system
(page 25).
To mount the Zone Ctrl II
To disconnect and mount the controller and actuator separately
Zone Ctrl II and
VAV Zone II Secondary Duct Installation and Start-up Guide
Error! No text of specified style in document.
6
CARRIER CORPORATION ©2019
All rights reserved
Advertisement
Table of Contents
