Table of Contents
Advertisement
Turn on the Printer again and connect your computer to the network. Open
REXprint, then click Print > Connect Machine. Select Wi-Fi as the Connect
Mode and enter the IP Address, as shown on the printer's screen. Click
Connect.
If you want to switch between AP and STA modes, touch the Reset button on
the WIFI Screen.
6.2.11 Updating the Firmware
Each time you start REXprint, it will automatically detects and downloads the up-
to-date firmware. If an update is available, a dialogue box will appear to remind
you of the update. Perform the following steps to update the firmware.
① Click Tools > Update firmware. You must sever any existing connection with
the printer before updating. If a connection exists, it will prompt you to cut
the connection. Click the Yes button to cut the connection.
② Choose the corresponding printer type and firmware version, then click OK
in the firmware update dialogue. After confirming that there is no printer
connection, the software will automatically update the firmware.
www.bresser.de
60
Advertisement
Table of Contents
