Bresser T-Rex Instruction Manual page 50

 Combine Infill: You can select the layers for combining according to the layer
thickness.
The combined thickness should not exceed 0.4mm. The Every N Layers
option is for all infill, while the Every N Inner Layers affects only the inner
infills, which generally save print time.
Speed: Click the Speed tab to reveal the speed settings.
 Print Speed: Determines the speed that the extruder moves while printing
filament. It can be set from 10 to 200 mm/sec in 10mm/sec increments. The
slower the speed, the higher quality the resulting printed models. For PLA
printing, 80mm/sec is recommended.
 Travel Speed: Determines the speed that the extruder moves while moving
from place to place and not actively printing filament. It can be set from 10 to
200 mm/sec in 10mm/sec increments. The slower the speed, the higher
quality the resulting printed models. For PLA printing, 100mm/sec is
recommended.
Temperature: Click the Temperature tab to reveal the temperature options.
 Right Extruder: Sets the operating temperature of the extruder from 0 to
248°C, in 5°C increments. Set the temperature according to the type of
filament being printed.
 Platform: Sets the operating temperature of the build platform from 0 to
120°C, in 5° increments. Set the temperature according to the type of filament
being printed.
Others: Click the Others tab to reveal additional options.
 Pause At Heights: Sets the height at which the print will automatically be
paused. This is usually done to allow you to change filament at one or points.
Click the Edit button to set the pause point(s). The print can be paused
anywhere from 1 to 59.9 mm.
www.bresser.de
50