Chapter 4: Hardware Assembly; Extruder Assembly - Bresser T-Rex Instruction Manual

Chapter 4: Hardware Assembly

The printer comes pre-assembled and is almost ready to print. All you need to
do is to set the appropriate voltage, mount the extruder set, and install the
filament. It will only take about 5-10 minutes to setup the printer and prepare
for your first 3D print!

4.1 Extruder Assembly

① Lay the extruder set on top of the
extruder seat with the two extruder
fans facing the front.
② Secure the extruder set onto the
extruder seat with two M3x8
screws, from the bottom up.
X-Axis Guide Rod
www.bresser.de
Bolt Hole
Bolt Hole
Hole
M3 x 8 bolts
Bolt Hole
Bolt
24