Table of Contents
Advertisement
6. Under Test cell configuration, select the test cell type, and then enter the
7. In the Navigation pane, click Sweep settings, and then enter the settings
8. In the Navigation pane, click Air reference measurement(s), and then
The next steps of the air reference measurement differ depending on whether
the air space height for all measurements is equal or for at least one
measurement is not equal to the sample thickness. Both cases are described
later in this section for a test cell with disk electrodes and guard ring.
In this case, perform one air reference measurement:
Air space height
is equal to the
1. In the Navigation pane, click Air reference measurement(s), and then click
sample thickness
2. Click the Start air reference button
3. The air reference measurement is running and the measurement results are
4. After the air reference measurement has finished, the status displayed next
5. Now, you can start the corre
5. Now, you can start the correction procedure (see 10.4.2 "Correction
In this case, perform two air reference measurements with different air space
In this case, perfo
Air space height
e height ht
heights:
heigh
heights:
is not equal to the
equal to the
o the
sample thickness
mple thickness
hickness
Note: We recommend performing the first measurement with the spacer higher
Note:
than the
than the sample thickness and the second measurement with the spacer lower
than t
than the sample thickness.
1
1. In the Navigation pane, click Air reference measurement(s), and then click
2. Click the Start air reference button
3. The air reference measurement is running and the measurement results are
4. After the first air reference measurement has finished, the status displayed
5. Click Start next to Air reference measurement (2).
test cell settings (see Table 10-10 "Test cell settings" on page 51).
(see Table 10-11 "Sweep settings" on page 52).
Note: The sweep settings depend on the measurement mode selected
under Measurement type.
enter the air reference settings (see Table 10-12 "Air reference settings" on
page 53).
Note: The air reference settings depend on the measurement mode
selected in the sweep settings under Measurement type.
Graph and result table. On the ribbon, the Reference(s) tab is selected
automatically.
air reference
next to Air reference measurement (1).
nce measurement ( .
eference measurement (1)
eference measuremen
eference measurement is running
displayed in the graph view.
yed in the graph view.
in the graph view.
er the air reference measureme
air reference meas
to Air reference measurement
to Air reference measurement (1) changes to Performed.
eference measur
u can start th
procedure" on page 46).
procedure" on page 46).
procedure" on page
Note: You can perform the air reference measurements before or after the
You can perfor
u ca
Note:
Not
material measurem
material me
material measurements.
n this case
We r
t
Graph and result table. On the ribbon, the Reference(s) tab selects
automatically.
next to Air reference measurement (1).
displayed in the graph view.
next to Air reference measurement (1) changes to Performed.
ment differ depending on whethe
is equal or for at least one
ual or for at least on
e thickness. Both
ess. Both cases are des
h disk electrodes and guard ring
trodes and g
erence measurement:
measurement:
lick Air reference measuremen
reference mea
ble. On the ribbon, the
n the ribbon, the Referenc
ce button
button
on the
on the
on the ribbon, and then click Start
on the ribbon, and then click Start
SPECTANO Analyzer Suite
elected
nt(s), and then
nd then
eference settings" on
ce settings" on
measurement mod
measurement mode
.
rement type
ment
depending on
cases a
Re
45
Advertisement
Table of Contents
